Nástroj na stredový bod vrchný | spodný
Forming process of making conical recess (center point). Used for locator, landmark and so on.
PRODUKTY > VYSEKÁVACIE NÁSTROJE > VYSEKÁVACIE NÁSTROJE > Špeciálne nástroje
Forming process of making conical recess (center point). Used for locator, landmark and so on.
Forming process of making tubes of threading for screw. Threading for screw and increased bearing area for tubes. Specific tool coating and treatment available for your specific application, ask to our expert at sales desk for a tailor-made consult.
Forming process of pierce half of material thickness. Used for locator or stopper.
Používa sa na vytvorenie priehlbiny. Tá sa potom môže použiť ako referenčný bod alebo na vytvorenie dekoratívneho vzoru na obrábanom materiáli.
Forming process of making a a chamfer to material. Used for sink a countersunk screw head, make chamfer to a corner after punching, guide of tapping.
Forming process of lance like Z figure. Used for hook, locator and stopper.
Vytvorenie vyvýšeného alebo zapusteného tvaru. Používa sa po zapustení hláv skrutiek alebo matíc. Môže sa použiť aj na oddelenie dvoch častí od seba.
Forming process of piercing a hole and keep the slug on the sheet metal by tabs. When using a hole, remove the slug using screwdriver.
Forming process of lance like a bridge.
Používa sa na vytvorenie vetracieho otvoru (otvorov) pre vetracie mriežky.
Tool for creating multiple holes.
The thread form may require these tools: 1. A pre-punch 2. Thread form (possibly with built in coin) 3. Separate coin tool (very rare for thick material).